How To Light An Electric Water Heater. If a button is what. Keep holding down the pilot knob or button for at least a minute after the flame ignites.
Need assistance to manually light my water heater. HomeImprovement from www.reddit.com
Lighting a hot surface ignition: Then, hold it down while completing the next step. After that, set your temperate knob to low.
The Recoil Starter Is Located On The Back Side And No More Than Three Pulls Are Required To Get It Star….Just Pulling Your Leg.
There are two types of water heaters. This will start the flow of gas so you can light the flame. Now you need to press the ignition button approximately once per second.
Wait Five Minutes To Filter Out Any Gas.
Keep the knob or pilot button pressed down as you relight the burner with a utility lighter. Keep your eye on the burner. Your unit may not have a dial.
Let Go Of The Pilot Knob Or Button.
So, an electric water heater is the same as a conventional water heater but without the pilot light. This will ensure the pilot remains lit. Water heaters are devices used to heat water.
Locate Your Hot Water Heater Access Panel, Typically On The Outside Of Your Rv, And Remove It.
While still holding the gas down, light that pilot. Rotate the button of gas control to the pilot position. Dial or rotate the gas control knob to the pilot position.
This Gives Any Gas In The Area Time To Clear, Which Is Important Because The Gas Is Highly Flammable.
Keep on doing this until you see that the status light begins to blink every few seconds. Hopefully, it is clearly labeled. Here are some instructions on how to do so.
Share
Post a Comment
for "How To Light An Electric Water Heater"
Post a Comment for "How To Light An Electric Water Heater"